GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2009 🢒 Corvette 🢒 Power and Signal Distribution 🢒 Data Communications 🢒 Instrument Cluster Head Up Display Replacement

Removal Procedure

    Object Number: 1224615 Size: SH
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection.
  2. Remove the instrument panel (I/P) assembly. Refer to Instrument Panel Assembly Replacement.
  3. Remove the retaining screw that secures the head up display (HUD) to the steering column bracket.
  4. Remove the HUD retaining nuts.
  5. Remove the HUD from the vehicle.

Installation Procedure

    Object Number: 378935 Size: SH
  1. Transfer the retaining screw and nut to the replacement HUD.
  2. Install the HUD to the vehicle:
    3. 2.1. Install the HUD onto the dash panel mounting studs.
    2.2. Slide the HUD retaining screw into the slot on the steering column bracket.

    Caution: Refer to Fastener Caution in the Preface section.

  3. Install the HUD retaining nuts.

    4. Tighten
    Tighten the nuts to 5 N·m (44 lb in).

  4. Tighten the screw that retains the HUD to the steering column bracket.

    5. Tighten
    Tighten the screw to 3 N·m (27 lb in).

  5. Install the I/P assembly. Refer to Instrument Panel Assembly Replacement.
  6. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection.
  7. Refer to Control Module References for programming and setup information.