GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2009 🢒 Corvette 🢒 Seats 🢒 Seat Hardware, Trim, and Upholstery 🢒 Driver or Passenger Seat Back Cushion Latch Release Cable Replacement

Removal Procedure

    Object Number: 71222 Size: SH
  1. Remove the seat back trim cover and pad. Refer to Front Seat Back Cushion Cover and Cushion Pad Replacement.
  2. Remove the seat back free play retention cable from the rear of the passenger seat back.

    3. Object Number: 71219 Size: SH
  3. Push down on the seat cushion to expose the hinge bolt nuts.
  4. Remove the right and left hinge bolt nuts.
  5. Remove the release cables from the hinge bolts.

    6. Object Number: 281998 Size: SH
  6. Remove the release cable mechanism from the upper seat back by depressing the taps and pushing the release lever out of the seat back frame.
  7. Remove the bezel from the release lever by spreading the bezel locking tabs.

Installation Procedure

    Object Number: 171524 Size: SH
  1. Insert the release cables through the opening in the upper seat back frame.
  2. Snap the release lever mechanism to the seat back frame.
  3. Route the cables.

    4. Object Number: 71219 Size: SH
  4. Install the release cables to the right and left hinges inserting the locking pins in the notches.
  5. Apply LOCTITE™ 271 to the hinge bolts.

    6. Caution: Refer to Fastener Caution in the Preface section.

  6. Install the nuts to the right and left hinge bolts.

    7. Tighten
    Tighten the nuts to 24 N·m (18 lb ft).

  7. Install the free play retention cable to the passenger seat back.

    8. Object Number: 71215 Size: SH
  8. Install the seat back trim cover and pad. Refer to Front Seat Back Cushion Cover and Cushion Pad Replacement.