GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2009 🢒 Corvette 🢒 Safety and Security 🢒 Supplemental Inflatable Restraints 🢒 Radio Replacement

Removal Procedure

    Object Number: 1237162 Size: SH
  1. Remove the cover from the instrument panel (I/P) electrical center.
  2. Remove the RDO/CD MiniFuse® #5 from the I/P electrical center.
  3. Remove the I/P accessory trim plate. Refer to Instrument Panel Accessory Trim Plate Replacement.
  4. Remove the HVAC control module. Refer to HVAC Control Module Replacement.
  5. Remove the screws retaining the radio control to the I/P center support bracket.
  6. Begin to remove the radio control from the center support bracket enough to access the connectors at rear of the radio control.
  7. Disconnect the electrical/audio and coaxial cable connectors from the radio control.
  8. Remove the radio control.

Installation Procedure
  1. Connect the electrical/audio and coaxial cable connectors to the radio control.
  2. Install the radio control into position in the I/P center support bracket.

    3. Align the radio control locator tab into the center support bracket locator hole.

    Caution: Refer to Fastener Caution in the Preface section.


    Object Number: 1237162 Size: SH
  3. Install the radio control retaining screws.

    4. Tighten
    Tighten the screws to 2.5 N·m (22 lb in).

  4. Install the HVAC control module. Refer to HVAC Control Module Replacement.
  5. Install the I/P accessory trim plate. Refer to Instrument Panel Accessory Trim Plate Replacement.
  6. Install the RDO/CD MiniFuse® #5 to the I/P electrical center.
  7. Install the cover to the I/P electrical center.
  8. Refer to Control Module References for programming and setup information.