GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2009 🢒 Corvette 🢒 Preface 🢒 Dangers, Warnings, and Cautions 🢒 Shift Control Assembly Replacement

Removal Procedure
  1. Remove the shift control knob. Refer to Transmission Control Lever Knob Replacement.

    2. Object Number: 180587 Size: SH
  2. Grasp the sides of the shift control boot and apply light pressure in toward the shift control lever to begin to release the shift boot retaining tabs from the instrument panel (I/P) accessory trim plate.
  3. Using light pressure, continue to release the remaining boot retaining tabs.

    4. Object Number: 71519 Size: SH
  4. Lift the boot away from the trim plate and remove the boot.
  5. Remove the I/P accessory trim plate. Refer to Instrument Panel Accessory Trim Plate Replacement.

    6. Object Number: 71524 Size: SH
  6. Remove the acoustic boot for the shiftier.
  7. Remove the shift control closeout boot retaining nuts.
  8. Remove the shift control closeout boot.

    9. Object Number: 180811 Size: SH
  9. Place the shiftier into NEUTRAL.
  10. Press down to engage the shift control neutral lock pin.

    11. Object Number: 71526 Size: SH
  11. Remove the transmission shift rod clamp bolt.
  12. Remove the shift control mounting bolts.
  13. Raise the shift control to release the locator from the shiftier bracket on the side of the driveline support assembly.
  14. Release the shift control from the transmission shift rod clamp and remove the shift control assembly.

Installation Procedure

    Object Number: 71526 Size: SH
  1. Install the shift control assembly to the transmission shift rod clamp.
  2. Lower the shiftier into position and insert the locator into the shiftier bracket on the side of the driveline support assembly.

    3. Caution: Refer to Fastener Caution in the Preface section.

  3. Install the shift control mounting bolts.

    4. Tighten
    Tighten the shift control mounting bolts to 30 N·m (22 lb ft).

  4. Install the transmission shift rod clamp bolt.

    5. Tighten
    Tighten the transmission shift rod clamp bolt to 30 N·m (22 lb ft).


    Object Number: 180816 Size: SH
  5. Lift to release the shift control neutral lock pin.

    6. Object Number: 71523 Size: SH
  6. Install the shift control closeout boot.

    7. Check that the closeout boot fully seats to the shift control lever seal and the base of the shift control assembly (1).

  7. Install the shift control closeout boot retaining nuts.

    8. Tighten
    Tighten the shift control closeout boot retaining nuts to 12 N·m (106 lb in).

  8. Install the acoustic boot.

    9. Object Number: 71519 Size: SH
  9. Install the I/P accessory trim plate. Refer to Instrument Panel Accessory Trim Plate Replacement.
  10. Install the shift control boot over the shift control lever.

    11. Object Number: 180589 Size: SH
  11. Align the shift control boot to the I/P accessory trim plate opening, then press to lock the boot retaining tabs.
  12. Adjust the shape of the boot for appearance, if necessary.
  13. Install the shift control knob. Refer to Transmission Control Lever Knob Replacement.
  14. Install the console. Refer to Console Replacement.