Adjustment Procedure
Match the shift control lever correctly with the selector lever connection.
Place the shift control lever in the P position. Verify that the selector lever connection
is all the way forward. If not, proceed with the following adjustment.
- Remove the battery and the battery tray. Refer to
Battery and Battery Tray Replacement
.
- Remove the floor console. Refer to
Front Floor Console Replacement
.
- Remove the air filter housing (2.5L).
- Place the shift control lever in the P position.
- Loosen the pinch bolt nut on the shift control lever.
- Place the selector lever connection all the way forward
on the transaxle case.
- Insert the shift control cable into the shift control lever tightly.
Notice: Refer to Fastener Notice in the Preface section.
- Secure the shift control cable with the shift control cable adjuster pinch bolt
and nut.
Tighten
Tighten the nut to 8 N·m (71 lb in).
- Install the floor console. Refer to
Front Floor Console Replacement
in
Instrument Panel, Gages and Console.
- Install the air filter housing (2.5L).
- Install the battery and the battery tray. Refer to
Battery and Battery Tray Replacement
.