GM Service Manual Online
For 1990-2009 cars only

Circuit Description

This diagnostic addresses if the ECM is not programmed.

DTC Descriptors

This diagnostic procedure supports the following DTC:

DTC P1615 Control Module Not Programmed

Conditions for Running the DTC

    • The ignition is ON, with the engine OFF.
    • DTC P1615 runs once an ignition cycle.

Conditions for Setting DTC

The ECM detects that programming is incomplete for more than 1 second.

Action Taken When the DTC Sets

    • The control module stores the DTC information into memory when the diagnostic runs and fails.
    • The malfunction indicator lamp (MIL) will not illuminate.
    • The control module records the operating conditions at the time the diagnostic fails. The control module stores this information in the Failure Records.
    • The driver information center, if equipped, may display a message.

Conditions for Clearing the DTC

    • A current DTC Last Test Failed clears when the diagnostic runs and passes.
    • A history DTC clears after 40 consecutive warm-up cycles, if no failures are reported by this or any other non-emission related diagnostic.
    • Clear the DTC with a scan tool.

Test Description

The numbers below refer to the step numbers on the diagnostic table.

  1. A DTC P1615 indicates the ECM is not programmed.

  2. Attempt to program the ECM. If the ECM fails to program a second time, replace the ECM.

DTC P1615

Step

Action

Yes

No

1

Did you perform the Diagnostic System Check - Engine Controls?

Go to Step 2

Go to Diagnostic System Check - Engine Controls

2

Program the engine control module (ECM).

Does DTC P1615 reset?

Go to Step 3

Go to Step 5

3

  1. Ensure that all tool connections are secure.
  2. Ensure the programming equipment is operating correctly.
  3. Ensure the correct software and the correct calibration is used.
  4. Attempt to program the ECM.

Does DTC P1615 reset?

Go to Step 4

Go to Step 5

4

Replace the engine control module (ECM). Refer to Engine Control Module Replacement .

Did you complete the replacement?

Go to Step 5

--

5

  1. Clear the DTCs with a scan tool.
  2. Turn OFF the ignition for 30 seconds.
  3. Start the engine.
  4. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records.

Did the DTC fail this ignition?

Go to Step 2

Go to Step 6

6

Observe the Capture Info with a scan tool.

Are there any DTCs that have not been diagnosed?

Go to Diagnostic Trouble Code (DTC) List

System OK