Circuit Description
When the ignition switch is turned to ON, the sensing and diagnostic module (SDM) will perform a turn-on test to diagnose critical malfunctions within the SDM itself.
Upon passing this test, ignition and deployment loop voltages are measured to ensure that they are within their normal voltage ranges. The SDM monitors the voltages at the driver low and the passenger low to detect shorts to ground or voltage in the deploy loops.
The SDM checks the wiring connection to the passenger air bag module by letting the infinitesimal current flow through the internal circuit and verify the resistance. If the resistance is 2-10 kilo ohms, the defect may occur depending upon SDM. The normal resistance is over 10 kilo ohms.
Conditions for Setting the DTC
| • | The air bag wiring of the passenger high is shorted to ground. |
| • | The air bag wiring of the passenger low is shorted to ground. |
Step | Action | Values | Yes | No |
|---|---|---|---|---|
|
Caution: Refer to Sensing and Diagnostic Module Voltage after Ignition is Turned Off Caution in the Preface section. Caution: Refer to Sensing and Diagnostic Module Handling Caution in the Preface section. | ||||
1 | Did you perform the Diagnostic System Check - SIR? | -- | Go to Step 2 | |
2 | Visually inspect the supplemental inflatable restraints (SIR) wiring harness. Is there any visible damage to the SIR harness? | -- | Go to Step 3 | Go to Step 4 |
3 | Replace the SIR wiring harness. Did you complete the repair? | -- | -- | |
4 |
Is the resistance as specified? | 10k ohms | Go to Step 5 | Go to Step 3 |
5 |
Is DTC 007 still shown as a current fault? | -- | Go to Step 6 | System OK |
6 | Replace the passenger side air bag module. Refer to Inflatable Restraint Instrument Panel Module Replacement . Did you complete the repair? | -- | -- | |
