GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2007 🢒 Epica 🢒 Diagnostic Navigation 🢒 Vehicle Diagnostic Information 🢒 Accelerator Pedal Position Sensor Replacement

Removal Procedure

    Object Number: 1679505 Size: SH
  1. Turn the ignition switch to the off position.
  2. Disconnect the electronic throttle control (ETC) connector from the accelerator pedal.

    3. Object Number: 1679506 Size: SH
  3. Remove the 3 accelerator pedal retaining bolts.
  4. Remove the accelerator pedal.

Installation Procedure

    Object Number: 1670940 Size: SH
  1. Position the accelerator pedal.

    2. Notice: Refer to Fastener Notice in the Preface section.

  2. Install the 3 accelerator pedal retaining nuts.

    3. Tighten

        • Tighten the upper accelerator pedal retaining bolts (1) to 10 N·m (89 lb in).
        • Tighten the lower accelerator pedal retaining bolt (2) to 23 N·m (17 lb ft).
  3. Connect the ETC connector to the accelerator pedal.