GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2007 🢒 Epica 🢒 Body Systems 🢒 Wipers and Washers 🢒 Windshield Wiper and Washer Switch Replacement

Removal Procedure

    Caution: Refer to Battery Disconnect Caution in the Preface section.


    Object Number: 1255836 Size: SH
  1. Disconnect the negative battery cable.
  2. Remove the upper and lower steering coumn cover panel screws.
  3. Remove the upper and lower steering column cover panels.

    4. Object Number: 1255839 Size: SH
  4. Remove the wiper switch by pushing in on the tabs on the top and the bottom of the switch housing.

    5. Object Number: 1255840 Size: SH
  5. Disconnect the electrical connectors from the wiper switch. Disconnect the cruise control connector, if equipped.

Installation Procedure

    Object Number: 1255840 Size: SH
  1. Connect the electrical connector to the wiper switch. Connect the cruise control connector, if equipped.

    2. Object Number: 1255839 Size: SH
  2. Install the wiper switch by snapping it into the switch housing.

    3. Notice: Refer to Fastener Notice in the Preface section.


    Object Number: 1255836 Size: SH
  3. Install the upper and the lower steering column cover panels. Install the upper and the lower steering column cover panel screws.

    4. Tighten
    Tighten the upper and the lower steering column cover panel screws to 2.5 N·m to (22 lb in).

  4. Connect the negative battery cable.