Removal Procedure
Caution: Refer to Battery Disconnect Caution in the Preface section.
Important: Left-Hand Drive Shown, Right-Hand Drive Similar.
- Disconnect the negative battery cable.
- Remove the audio system trim plate. Refer to
Radio Replacement
.
- Remove the 4 controller retaining screws.
- Disconnect the electrical connectors.
- Remove the control assembly.
Installation Procedure
- Connect the electrical connectors to the sockets on the back of the controller.
- Gently insert the controller into position on the center console.
Notice: Refer to Fastener Notice in the Preface section.
- Install the retaining screws.
Tighten
Tighten the controller retaining screws to 4 N·m (35 lb in).
- Connect the negative battery cable.
- Confirm the proper operation of the controller by moving it through all of the controller's possible functioning positions.
- Install the audio system trim plate. Refer to
Radio Replacement
.