Accelerator Pedal Position Sensor Replacement for Chevrolet Epica 2009

1. Turn the ignition switch to the off position.
2. Disconnect the electronic throttle control (ETC) connector from the accelerator pedal.



3. Remove the 3 accelerator pedal retaining bolts.
4. Remove the accelerator pedal.

1. Position the accelerator pedal.

Caution: Refer to Fastener Caution in the Preface section.

2. Install the 3 accelerator pedal retaining nuts and tighten.

•	The upper accelerator pedal retaining bolts (1) to 10 N·m (89 lb in).

•	The lower accelerator pedal retaining bolt (2) to 23 N·m (17 lb ft).

3. Connect the ETC connector to the accelerator pedal.