For 1990-2009 cars only
Removal Procedure
- Disconnect the negative battery cable.
- Remove the console. Refer to Front Floor Console Replacement.
- Disconnect the shift control cables from the shift control lever housing.
- Remove the nuts from the shift control lever housing.
- Remove the shift control lever housing.
- Remove the shift control cable adjust locks (1).
- Remove the shift control cables (2) from the shift control lever housing bracket.
- Disconnect the shift control cables from the shift control adjusters.
- Remove the shift control cables (1) from the transaxle using a suitable tool.
- Remove the cables (2) from the shift control cable bracket.
- Remove the grommet from the dash panel.
- Remove the shift control cables from the vehicle.
Warning: Refer to Battery Disconnect Warning in the Preface section.
Installation Procedure
- Install the shift control lever housing.
- Install the nuts to the shift control lever housing and tighten to 8 N·m (71 lb in).
- Connect the shift cables to the shift control lever housing, and adjust the cable.
- Install the shift control cables to the vehicle.
- Install the grommet from the dash panel.
- Install the cables (2) to the shift control cable bracket.
- Install the shift control cables (1) to the transaxle.
- Position the transaxle into Neutral.
- Install the shift control cables to the shift control lever housing bracket.
- Position the shift lever into Neutral.
- With the shift cable ends in the adjusters, adjust the cables by pushing the neutral lock pin. Move the shifter slightly to center the neutral lock pin.
- Press and lock the shift control cable adjust locks.
- Pull the neutral lock pin to the original position.
- Install the console. Refer to Front Floor Console Replacement.
- Connect the negative battery cable.
Caution: Refer to Fastener Caution in the Preface section.
Note: Ensure that the shift control cable pass-through grommet is properly seated and the grommet arrow is pointing up.
