Important: The vehicle must be in PARK prior to ignition cylinder removal.

1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
2. Disable the SIR system. Refer to SIR Disabling and Enabling .
3. Remove the steering column trim covers. Refer to Steering Column Trim Covers Replacement .
4. Remove the park lock cable from the bottom of the housing. Refer to Park Lock Cable Replacement .



5. Insert the key into the ignition and rotate to the ACC position.



6. Depress the locking button through hole on the side of ignition module assembly with a thin pick-type tool.

Important: Once the locking button is depressed, the tool must be removed before the cylinder wil slide out of the housing.

7. Slide the lock cylinder out of the ignition housing.

Important: The actuator blade within the ignition module must be in ACC position to install the lock cylinder assembly. If rotated, reposition the actuator blade to the ACC position using needle nose pliers.

Important: If you are installing a new lock cylinder, refer to Key and Lock Cylinder Coding .

1. Insert the key into ignition lock cylinder and install the cylinder into the lock housing.
2. Rotate the lock cylinder in the housing. Verify proper rotation.
3. Install the park lock cable to the bottom of the housing. Refer to Park Lock Cable Replacement .
4. Install the steering column trim covers. Refer to Steering Column Trim Covers Replacement .
5. Enable the SIR system. Refer to SIR Disabling and Enabling .
6. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .