GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2005 🢒 Equinox 🢒 General Information 🢒 General Information 🢒 Rear Axle Upper Control Arm Replacement

Removal Procedure
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .

    2. Object Number: 930291 Size: SH
  2. Remove the trailing arm bracket to body bolts.

    3. Object Number: 929585 Size: SH
  3. If applicable, remove the antilock brake system (ABS) brake harness from the upper control arm.
  4. Remove the upper control arm to knuckle nut and bolt.

    5. Object Number: 930288 Size: SH
  5. Remove the upper control to support nut and bolt.
  6. Remove the upper control arm.

Installation Procedure

    Object Number: 930285 Size: SH
  1. Install the upper control arm to the knuckle.
  2. Loosely install the upper control arm to knuckle nut and bolt.

    3. Object Number: 930288 Size: SH
  3. Install the upper control to support bolt and cam nut.

    4. Notice: Refer to Fastener Notice in the Preface section.

  4. Tighten the upper control arm to knuckle nut and bolt.

    5. Tighten
    Tighten the nut and bolt to 160 N·m (118 lb ft).

  5. Tighten the upper control arm to support bolt.

    6. Tighten
    Tighten the upper control arm to support bolt to 160 N·m (118 lb ft).

  6. If applicable, install the ABS harness to the upper control arm.

    7. Object Number: 930291 Size: SH
  7. Push upward on the trailing arm and loosely install the front bolt.
  8. Use a drift to align the remaining bolts.

    9. Tighten
    Tighten the trailing arm bracket to body bolts to 110 N·m (81 lb ft).

  9. Lower the vehicle.
  10. Check the rear alignment. Refer to Wheel Alignment Measurement .