Radiator Inlet Hose Replacement Chevrolet

1. Drain the coolant. Refer to Cooling System Draining and Filling.
2. Remove the upper fascia retainers from the radiator support.
3. Remove the upper radiator bracket bolt from the radiator support.
4. Remove the upper radiator bracket from the radiator.
5. Remove the radiator inlet hose clamp from the radiator.



6. Remove the radiator inlet hose from the radiator.



7. Remove the radiator inlet hose clamp from the engine.
8. Remove the radiator inlet hose from the engine.

1. Install the radiator inlet hose to the engine.
2. Install the radiator inlet hose clamp to the engine.



3. Install the radiator inlet hose to the radiator.



4. Install the radiator inlet hose clamp to the radiator.
5. Install the upper radiator bracket to the radiator.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

6. Install the upper radiator bracket bolt to the radiator support.

Tighten
Tighten the bolt to 8 N·m (71 lb in).

7. Install the upper fascia retainers to the radiator support.
8. Fill the cooling system. Refer to Cooling System Draining and Filling.

Radiator Inlet Hose Replacement Pontiac

1. Partially drain the coolant. Refer to Cooling System Draining and Filling .



2. Remove the powertrain control module (PCM) wire harness (2) from the battery box cover.
3. Remove the PCM bracket with PCM (1) from the top of the battery box cover.
4. Carefully position the PCM and bracket out of the way.



5. Loosen the screws securing the battery box cover.
6. Remove the battery box cover (1).



7. Remove the battery box vent tube from the side of the battery box.



8. Remove the radiator inlet hose clamp from the radiator.
9. Remove the radiator inlet hose from the radiator.



10. Remove the radiator inlet hose clamp from the engine.
11. Remove the radiator inlet hose from the engine.

1. Install the radiator inlet hose to the engine.
2. Install the radiator inlet hose clamp to the engine.



3. Install the radiator inlet hose to the radiator.
4. Install the radiator inlet hose clamp to the radiator.



5. Install the battery box vent tube to the side of the battery box.

Notice: Refer to Fastener Notice in the Preface section.




6. Install the battery box cover (1).

Tighten
Tighten the screws to 2 N·m (18 lb in).




7. Install the PCM bracket with PCM (1) to the top of the battery box cover.
8. Install the PCM wire harness (2) to the battery box cover.
9. Fill the cooling system. Refer to Cooling System Draining and Filling .