GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2006 🢒 Equinox 🢒 Vehicle Control Systems 🢒 Vehicle DTC Information 🢒 Coolant Heater Replacement

Removal Procedure

    Object Number: 1356827 Size: SH
  1. Drain the engine coolant. Refer to Cooling System Draining and Filling .
  2. Remove the coolant heater cord from the heater (2).

    3. Important: Do not score the surface of the engine block hole when removing the coolant heater.

  3. Remove the coolant heater from the block.

Installation Procedure

    Object Number: 1356827 Size: SH
  1. Remove any burrs, sealer, paint or other foreign material from the threads/sealing surface of the engine block and from the old coolant heater if the heater is to be reused.
  2. If reusing the old coolant heater, apply thread sealant GM P/N 12346004 (Canadian P/N 10953480), or equivalent to the threads.

    3. Notice: Refer to Component Fastener Tightening Notice in the Preface section.

  3. Install the coolant heater to the engine block.

    4. Tighten
    Tighten the coolant heater to 50 N·m (37 lb ft).

  4. Install the coolant heater cord to the heater (2).
  5. Fill the cooling system. Refer to Cooling System Draining and Filling .