Remote Keyless Entry (RKE) System Operation for Chevrolet Equinox 2008
The Remote Keyless Entry (RKE) transmitter functions will work up to 195 feet (60 m) away, however, the operating range may be less while the vehicle is running.
There are other conditions which can affect the performance of the transmitter. See Remote Keyless Entry (RKE) System .
With Remote Start Shown, Without Remote Start Similar
(Remote Vehicle Start): If your vehicle has this feature, press to start the engine from outside the vehicle using the RKE transmitter. See Remote Vehicle Start for additional information.
[block ] (Lock): Press to lock the doors and liftgate. If enabled through the Driver Information Center (DIC), the parking lamps will flash once to indicate locking has occurred. If enabled through the DIC, the horn will chirp when [block ] is pressed again within five seconds of the previous press of the lock button. See DIC Vehicle Personalization for additional information. Pressing [block ] may arm the content theft-deterrent system. See Content Theft-Deterrent .
(Unlock): Press to unlock the driver's door. If is pressed again within five seconds, all remaining doors, and the liftgate, will unlock. The interior lamps will come on and stay on for 20 seconds or until the ignition is turned on. If enabled through the DIC, the parking lamps will flash twice to indicate unlocking has occurred. See DIC Vehicle Personalization . Pressing on the RKE transmitter will disarm the content theft-deterrent system. See Content Theft-Deterrent .
(Vehicle Locator/Panic Alarm): Press and release to locate your vehicle. The turn signal lamps will flash and the horn will sound three times. Press and hold for more than two seconds to activate the panic alarm. The turn signal lamps will flash and the horn will sound repeatedly for 30 seconds. The alarm will turn off when the ignition is moved to ON/RUN or is pressed again. The ignition must be in LOCK/OFF for the panic alarm to work.
The RKE transmitter is used to arm/disarm the content theft-deterrent system. Your vehicle's theft-deterrent system can be programmed to three different modes. See Content Theft-Deterrent .
If you accidentally set off the alarm when entering or exiting the vehicle, you can shut it off by pressing [block ] or once or twice.
Matching Transmitter(s) to Your Vehicle
Each RKE transmitter is coded to prevent another transmitter from unlocking your vehicle. If a transmitter is lost or stolen, a replacement can be purchased through your dealer/retailer. All transmitters need to be re-coded to match the new transmitter. The lost transmitter will no longer work after the new transmitters are re-coded. The vehicle can have a maximum of four transmitters matched to it. Or, see "Learn Remote Key" under DIC Operation and Displays for instructions on how to match RKE transmitters to your vehicle.
Battery Replacement
The battery is weak if the transmitter will not work at the normal range in any location. If you have to get close to your vehicle before the transmitter works, change the battery.
Notice: When replacing the battery, do not touch any of the circuitry on the transmitter. Static from your body could damage the transmitter.
To replace the battery in the RKE transmitter:
- Separate the halves of the transmitter with a flat, thin object inserted into the notch on the side.
- Remove the old battery. Do not use a metal object.
- Insert the new battery, positive side facing down. Replace with a CR2032 or equivalent battery.
- Put the transmitter back together tightly.
The Remote Keyless Entry (RKE) transmitter functions will work up to 65 feet (20 m) away.
There are other conditions which can affect the performance of the transmitter. See Remote Keyless Entry (RKE) System .
The following functions may be available if your vehicle has the RKE system:
[block ] (Lock): Press to lock the doors and liftgate. If enabled through the Driver Information Center (DIC), the parking lamps will flash once to indicate locking has occurred. If enabled through the DIC, the horn will chirp when the lock button is pressed again within five seconds of the previous press of the lock button. See DIC Vehicle Personalization for additional information.(Unlock): Press to unlock the driver's door. If the button is pressed again within five seconds, all remaining doors, and the liftgate, will unlock. The interior lamps will come on and stay on for 20 seconds or until the vehicle is turned on. If enabled through the DIC, the parking lamps will flash once to indicate unlocking has occurred. See DIC Vehicle Personalization .
(Vehicle Locator/Panic Alarm): Press and release to locate your vehicle. The turn signal lamps will flash and the horn will sound three times. Press and hold this button for more than two seconds to activate the panic alarm. The turn signal lamps will flash and the horn will sound repeatedly for 30 seconds. The alarm will turn off when the key is moved to System On or is pressed again. The key must be in System Off for the panic alarm to work.
Matching Transmitter(s) to Your Vehicle
Each RKE transmitter is coded to prevent another transmitter from unlocking your vehicle. If a transmitter is lost or stolen, contact your Driver Relationship Manager (DRM) for a replacement. Remember to bring any additional transmitters so they can also be re-coded to match the new transmitter. Once your Driver Relationship Manager (DRM) has coded the new transmitter, the lost transmitter will not unlock your vehicle. The vehicle can have a maximum of four transmitters matched to it. Or, see "Learn Remote Key" under DIC Operation and Displays for instructions on how to match RKE transmitters to your vehicle.
Battery Replacement
Under normal use, the battery in your RKE transmitter should last about four years.
The battery is weak if the transmitter will not work at the normal range in any location. If you have to get close to your vehicle before the transmitter works, it is probably time to change the battery.
Notice: When replacing the battery, do not touch any of the circuitry on the transmitter. Static from your body could damage the transmitter.
To replace the battery in the RKE transmitter:
- Use a flat thin object to pry open the transmitter.
- Once the transmitter is separated, use a pencil or similar object to remove the old battery. Do not use a metal object.
- Slide the new battery into the transmitter with the positive side of the battery facing down. Use a type CR2032 battery, or equivalent type.
- Snap the transmitter back together tightly to be sure no moisture can enter.
- Check the operation of the transmitter.
