GM Service Manual Online
For 1990-2009 cars only

Exhaust Manifold Heat Shield Replacement - Left Side LNJ

Removal Procedure


    Object Number: 1087638  Size: SH
  1. Remove the heat shield bolts (2).
  2. Remove the heat shield (1) from the exhaust manifold.

Installation Procedure


    Object Number: 1087638  Size: SH
  1. Install the heat shield (1) to the exhaust manifold.
  2. Notice: Refer to Fastener Notice in the Preface section.

  3. Install the heat shield bolts (2) to the exhaust manifold.
  4. Tighten
    Tighten the bolts to 10 N·m (89 lb in).

Exhaust Manifold Heat Shield Replacement - Left Side LY7

Removal Procedure

Caution: Refer to Exhaust Service Caution in the Preface section.

Caution: Refer to Protective Goggles and Glove Caution in the Preface section.


    Object Number: 1836024  Size: SH
  1. Remove the fuel injector sight shield, if necessary. Refer to Fuel Injector Sight Shield Replacement .
  2. Disconnect the engine wiring harness electrical connector (3) from the heated oxygen sensor (HO2S) electrical connector (4).
  3. Remove the HO2S electrical connector retainer (5) from the retainer clip.

  4. Object Number: 1836984  Size: SH
  5. Remove the exhaust manifold heat shield bolts.
  6. Remove the exhaust manifold heat shield, sliding the shield up over the HO2S pigtail.

Installation Procedure


    Object Number: 1836984  Size: SH
  1. Install the exhaust manifold heat shield, sliding the shield down over the HO2S pigtail.
  2. Notice: Refer to Fastener Notice in the Preface section.

  3. Install the exhaust manifold heat shield bolts.
  4. Tighten
    Tighten the bolts to 10 N·m (89 lb in).


    Object Number: 1836024  Size: SH
  5. Connect the engine wiring harness electrical connector (3) to the HO2S electrical connector (4).
  6. Install the HO2S electrical connector retainer (5) to the retainer clip.
  7. Install the fuel injector sight shield, if necessary. Refer to Fuel Injector Sight Shield Replacement .