For 1990-2009 cars only
Tools Required
| • | EN 46359 Puller End Protector |
| • | EN-49010 Flywheel Holding Tool |
| • | J 41816-A Crankshaft Balancer Remover |
- Install the EN-49010 to the starter mounting holes.
- Remove the crankshaft balancer bolt and washer.
- Remove the crankshaft balancer using the J 41816-A along with EN 46359 or equivalent.
- Remove the EN-49010 .
Notice: Do NOT use a power-assisted tool with the special tool in order to remove or install this component. You cannot properly control the alignment of this component using a power-assisted tool, and this can damage the component.
