Preliminary Procedure

Remove the liftgate interior trim panel. Refer to Liftgate Trim Panel Replacement .

1

Liftgate Garnish Molding Nut (Qty: 2)

Notice: Refer to Fastener Notice in the Preface section.

Tighten
2 N·m (18 lb in)

2

Liftgate Garnish Molding Bolt

Tighten
2 N·m (18 lb in)

3

Liftgate Garnish Molding Assembly

Tip
Remove the molding from the liftgate by pulling away from the liftgate to disengage the remaining retainers.

Notice: Refer to Fastener Notice in the Preface section.

Fastener Tightening Specifications: Refer to Fastener Tightening Specifications .

Preliminary Procedures

1. Open the liftgate.
2. Remove the liftgate interior trim panel. Refer to Liftgate Trim Panel Replacement .
3. Remove the center applique screw from inside the liftgate panel.
4. Remove the 2 outer applique nuts, also from inside the liftgate.

1

Liftgate Center Applique Assembly Screw

Tighten
2 N·m (18 lb in)

2

Liftgate Center Applique Assembly Nuts (Qty: 2)

Tighten
4 N·m (35 lb in)

3

Liftgate Center Applique Assembly Retainers (Qty: 2)

Tip
Release the retainers from inside the applique panel.

4

Adhesive Tape

Tip
Release the adhesive tape backing and wet out after the rear applique has been installed to the liftgate panel.

5

Liftgate Center Applique Assembly