GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2008 🢒 Equinox 🢒 General Information 🢒 General Information 🢒 Transfer Case Bracket Replacement

Removal Procedure
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the right hand axle. Refer to Front Wheel Drive Shaft Replacement .

    3. Object Number: 1371165 Size: SH
  3. Disconnect the electrical connectors from the crankshaft position sensor (2) and the knock sensor (1).

    4. Object Number: 928962 Size: SH
  4. Remove the bolts from the transfer case mounting bracket and engine.
  5. Remove the bracket.

Installation Procedure

    Notice: Refer to Fastener Notice in the Preface section.


    Object Number: 928962 Size: SH
  1. Position the transfer case mounting bracket to the vehicle and hand start all bolts.

    2. Tighten
    Tighten the bolts to 50 N·m (37 lb ft).


    Object Number: 1371165 Size: SH
  2. Connect the electrical connectors to the crankshaft position sensor (2) and the knock sensor (1).
  3. Install the right hand axle. Refer to Front Wheel Drive Shaft Replacement .
  4. Lower the vehicle.