GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2009 🢒 Equinox 🢒 Engine 🢒 Engine Mechanical - 3.4L 🢒 Ignition Control Module Bracket Replacement

Removal Procedure

    Object Number: 1087898 Size: SH
  1. Disconnect the negative battery cable. Refer to Lifting and Jacking the Vehicle.
  2. Remove the injector sight shield. Refer to Fuel Injector Sight Shield Replacement.
  3. Disconnect the ignition coil/control module electrical connectors.
  4. Remove the spark plug wire retainer (1) from the ignition control module bracket.
  5. Remove the 4 bolts securing the ignition coil/control module to the ignition control module bracket.
  6. Position the ignition coil/control module aside out of the way.
  7. Remove the bolt (3) from the fuel injector wire harness bracket (4) and positive crankcase ventilation (PCV) valve fresh air tube retainer.
  8. Remove the engine wire harness retainers from the ignition control module bracket studs (5).

    9. Object Number: 1087631 Size: SH
  9. Remove the nut (1) retaining the heater outlet pipe.
  10. Lift pipe up slightly to gain access for the removal of the 2 ignition control module bracket bolts.

    11. Object Number: 1087898 Size: SH
  11. Remove the ignition control module bracket bolts (2).
  12. Remove the ignition control module bracket nuts (6).
  13. Remove the ignition control module bracket.

Installation Procedure

    Object Number: 1087898 Size: SH
  1. Install the ignition control module bracket.

    2. Caution: Refer to Fastener Caution in the Preface section.

  2. Install the ignition control module bracket nuts (6).

    3. Tighten
    Tighten the nuts to 25 N·m (18 lb ft).

  3. Install the ignition control module bracket bolts (2).

    4. Tighten
    Tighten the bolts to 25 N·m (18 lb ft).


    Object Number: 1087631 Size: SH
  4. Install the nut (1) retaining the heater outlet pipe.

    5. Tighten
    Tighten the nut to 25 N·m (18 lb ft).


    Object Number: 1087898 Size: SH
  5. Install the engine wire harness retainers to the ignition control module bracket studs (5).
  6. Install the bolt (3) from the fuel injector wire harness bracket (4) and PCV valve fresh air tube retainer.

    7. Tighten
    Tighten the bolts to 5 N·m (44 lb in).

  7. Install the ignition coil/control module to the ignition control module bracket.
  8. Install the 4 bolts securing the ignition coil/control module to the ignition control module bracket.

    9. Tighten
    Tighten the bolts to 4.5 N·m (40 lb in).

  9. Install the spark plug wire retainer (1) to the ignition control module bracket.
  10. Connect the ignition coil/control module electrical connectors.
  11. Install the injector sight shield. Refer to Fuel Injector Sight Shield Replacement.
  12. Connect the negative battery cable. Refer to Lifting and Jacking the Vehicle.