Special Tools

J 45059 Angle Meter

For equivalent regional tools, refer to Special Tools.

Caution: This component uses torque-to-yield bolts. When servicing this component do not reuse the bolts, New torque-to-yield bolts must be installed. Reusing used torque-to-yield bolts will not provide proper bolt torque and clamp load. Failure to install NEW torque-to-yield bolts may lead to engine damage.

1. Install the cylinder head locator dowel pins, if necessary.
2. Inspect the cylinder head locator dowel pins for proper installation.
3. Install the cylinder head gasket.



4. Install the cylinder head.

Caution: Refer to Fastener Caution in the Preface section.




5. Install the new cylinder head bolts.

5.1.	Tighten the cylinder head bolts a first pass in sequence to 60 N·m (44 lb ft).

5.2.	Tighten the cylinder head bolts a final pass in sequence to 95 degrees using the J 45059 meter .