GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2009 🢒 Equinox 🢒 Diagnostic Navigation 🢒 Vehicle Diagnostic Information 🢒 Output Speed Sensor Replacement

Removal Procedure
  1. Remove the battery tray. Refer to Battery Tray Replacement.

    2. Object Number: 1827300 Size: SH
  2. Disconnect the electrical connector (2) from the output shaft speed sensor.

    3. Object Number: 1827302 Size: SH
  3. Remove the output speed sensor bolt.
  4. Remove the output shaft speed sensor and the O-ring.

Installation Procedure

    Object Number: 1827302 Size: SH
  1. Apply GM T-IV automatic transaxle fluid GM P/N 88900925 to the new output speed sensor O-ring.
  2. Install the new output speed sensor O-ring onto the output speed sensor (2).
  3. Install the output speed sensor into the transmission case assembly.

    4. Caution: Refer to Fastener Caution in the Preface section.

  4. Install the output speed sensor bolt and tighten to 5 N·m (44 lb in).

    5. Object Number: 1827300 Size: SH
  5. Connect the electrical connector (2) to the output shaft speed sensor.
  6. Install the battery tray. Refer to Battery Tray Replacement.