Note: The EVAP emissions canister is located under the center of the vehicle. It has 3 EVAP line connections:

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.

Caution: Clean all fuel pipe connections and surrounding areas before disconnecting the fuel pipes to avoid contamination of the fuel system.

2. Disconnect the EVAP canister fresh air hose/pipe from the fuel tank fresh air hose/pipe (2).
3. Disconnect the fuel tank vent pipe (3) from the EVAP canister.



4. Disconnect the chassis EVAP pipe (1) from the EVAP canister.
5. Remove the EVAP canister-to-underbody nuts (3).
6. Lower the EVAP canister (4).



7. Disconnect the EVAP vent solenoid electrical connector (1).
8. Remove the EVAP canister (4) from the vehicle.

1. Connect the EVAP vent solenoid electrical connector (1).
2. Install the EVAP canister (4) to the underbody of the vehicle.

Caution: Refer to Fastener Caution in the Preface section.




3. Install the EVAP canister-to-underbody nuts (3).

Tighten
Tighten the nuts to 9 N·m (80 lb in).

4. Connect the chassis EVAP pipe (1) to the EVAP canister.



5. Connect the fuel tank vent pipe (3) to the EVAP canister.
6. Connect the EVAP canister fresh air hose/pipe to the fuel tank fresh air hose/pipe (2).
7. Lower the vehicle.