Note: The throttle actuator control (TAC) module is not replaceable separate of the throttle body assembly. If the TAC module requires replacement the entire throttle body assembly must be replaced.

1. Remove the air cleaner intake duct. Refer to Air Cleaner Inlet Duct Replacement.
2. Remove the heater outlet pipe. Refer to Heater Outlet Pipe Replacement.
3. Cover the throttle body opening with a shop towel and use the shop air to remove any dirt at the base of the throttle body.



4. Disconnect the TAC module electrical connector (1) by pulling up on the connector lock (2) to release the connector from the TAC module (3).



5. Remove the throttle body bolts (2).
6. Remove the throttle body (1) from the intake manifold.
7. Block the intake manifold opening with a clean shop towel to prevent dirt from entering.
8. Remove the throttle body studs ONLY If replacement of stud is necessary.

Caution: Refer to Fastener Caution in the Preface section.

1. Install the throttle body studs if previously removed.

Tighten
Tighten the throttle body stud to 6 N·m (53 lb in).




2. Install the throttle body (1) to the intake manifold.
3. Install the throttle body bolts.

Tighten
Tighten the throttle body-to-intake manifold bolts to 10 N·m (89 lb in).




4. Connect the TAC module electrical connector (1) to the TAC module (3) then press down the connector lock (2) in order to secure the TAC module electrical connector.
5. Install the heater outlet pipe. Refer to Heater Outlet Pipe Replacement.
6. Install the air cleaner intake duct. Refer to Air Cleaner Inlet Duct Replacement.