Warning: In order to prevent SIR deployment, personal injury, or unnecessary SIR system repairs, do not strike the door or the door pillar in the area of the side impact sensor (SIS). Turn OFF the ignition and remove the key when performing service in the area of the SIS.

Preliminary Procedures

1. Disable the supplemental inflatable restraint (SIR) system. Refer to SIR Disabling and Enabling.
2. Remove the rear door trim panel. Refer to Rear Side Door Trim Panel Replacement.

1

Rear Side Door Check Link Bolt

Caution: Refer to Fastener Caution in the Preface section.

Tighten
20 N·m (15 lb ft)

2

Rear Side Door Upper Hinge Bolt (Qty: 2)

Procedure

1. Remove the water deflector.
2. Support the door before removing the hinge bolts.
3. Disconnect the electrical connector.
4. With the aid of an assistant, remove the door.

Tighten
25 N·m (18 lb ft)

3

Rear Side Door Lower Hinge Bolt (Qty: 2)

Tighten
25 N·m (18 lb ft)

4

Rear Side Door Assembly

Procedure

1. When replacing the door it is necessary to transfer all of the internal components.
2. Apply LOCTITE® Blue GM P/N 12345382, or (Canadian P/N 10953489), or equivalent to the fastener prior to installation.
3. Verify door is properly aligned. If door adjustments are needed, refer to Rear Door Adjustment.