GM Service Manual Online
For 1990-2009 cars only

Removal Procedure


    Object Number: 173012  Size: SH
  1. Disconnect the battery negative cable from the battery. Refer to Battery Cable Replacement in Engine Electrical.
  2. Raise the vehicle and support with safety stands.
  3. Remove the oil pan from the engine block. Refer to Oil Pan Replacement .
  4. Remove the oil pump mounting bolts.
  5. Remove the oil pump assembly from the crankshaft rear bearing cap.

Installation Procedure

Important: When installing the oil pump. assembly to the engine block, always replace the retainer between the oil pump and the hex drive shaft.


    Object Number: 173012  Size: SH
  1. Prime the oil pump assembly.
  2. 1.1. Submerge the oil pump in a clean container with clean motor oil.
    1.2. Rotate the oil pump hex drive by hand until the oil begins to flow from the oil pump assembly.
    1.3. Clean the excess motor oil from the oil pump assembly.
    1.4. Install the new retainer between the oil pump and the hex drive.

    Important: Align the extension shaft with the drive shaft to the oil pump drive gear. the oil pump should slide easily into place, do not force the oil pump into place.

  3. Install the oil pump and the extension shaft to the crankshaft rear bearing cap.

  4. Object Number: 173012  Size: SH

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  5. Install the oil pump mounting bolts to the oil pump.
  6. Tighten
    Tighten the bolts to 90 N·m (65 lb ft).


    Object Number: 60264  Size: SH
  7. Install the oil pan to the engine block. Refer to Oil Pan Replacement .
  8. Remove the safety stands and lower the vehicle.
  9. Connect the battery negative cables to the batteries. Refer to Battery Cable Replacement in Engine Electrical.