Removal Procedure
- Open the hood.
- Remove the engine cover from the vehicle. Refer to Engine Cover Replacement in Interior Trim.
- Disconnect the battery negative cable from the battery. Refer to Battery Cable Replacement in Engine Electrical.
- Remove the transmission from the vehicle. Refer to Transmission Replacement or Transmission Replacement in Transmission/Transaxle.
- Remove the flywheel bolts from the crankshaft.
- Remove the flywheel from the crankshaft.
Caution: Before servicing any electrical component, the ignition and start switch must be in the OFF or LOCK position and all electrical loads must be OFF, unless instructed otherwise in these procedures. If a tool or equipment could easily come in contact with a live exposed electrical terminal, also disconnect the negative battery cable. Failure to follow these precautions may cause personal injury and/or damage to the vehicle or its components.
Installation Procedure
- Install the flywheel to the crankshaft.
- Install the flywheel bolts.
- Install the transmission in the vehicle. Refer to Transmission Replacement or Transmission Replacement in Transmission/Transaxle.
- Install the engine cover in the vehicle. Refer to Engine Cover Replacement in Interior Trim.
- Connect the battery negative cable to the battery. Refer to Battery Cable Replacement in Engine Electrical.
- Close the hood.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the bolts to 88 N·m (65 lb ft).
