Tools Required

1. Rotate the stub shaft back and forth in order to drain the power steering fluid.
2. Remove the coupling shield retainer and the lock nut from the steering gear housing using J 43435 and a torque wrench.



3. Remove the adjuster nut assembly (2) from the steering gear housing (1) using J 42882



4. Remove the thrust support assembly (2) from the steering gear housing (1).
5. Remove the O-ring seal (3) from the thrust support assembly (2).

Tools Required

J 42882 Adjuster Nut Socket

Important: Install a new O-ring seal each time the thrust support assembly is removed from the steering gear.

1. Lubricate the new O-ring seal (3).
2. Install the new O-ring seal (3) on the thrust support assembly (2).
3. Install the thrust support assembly (2).



4. Connect the adjuster nut assembly (2) to the steering gear housing (1) using J 42882 .
5. Install the coupling shield retainer and the lock nut (1) to the adjuster nut assembly.
6. Refer to Steering Gear Worm Gear Thrust Bearing Preload Adjustment - Off Vehicle to adjust the thrust bearing preload.



7. Install the coupling shield retainer and the lock nut.
8. Hold the adjuster nut assembly in position to maintain alignment of the marks.
9. Tighten the coupling shield retainer and the lock nut usingJ 43435 and a torque wrench.

Tighten
Tighten the coupling shield retainer and the lock nut (2) to 109 N·m (80 lb ft).

10. Refer to Steering Gear Worm Gear Thrust Bearing Preload Adjustment - Off Vehicle to adjust the pitman shaft over-center preload.