Tools Required

J 42640 Steering Column Anti-Rotation Pin

Important: Position the wheels straight ahead, and lock the steering column.

1. Disable the SIR system. Refer to Disabling the SIR System in SIR.
2. Remove the left knee bolster. Refer to Driver Knee Bolster Replacement in Instrument Panel Gauges and Console.
3. Remove the shift cable from the steering column.



4. Install the J-42640 anti-rotation pin in the lower steering column shroud access hole.
5. Remove the Intermediate shaft from the steering gear. Refer to Intermediate Steering Shaft Replacement .
6. Remove the electrical connectors.



7. Remove the column bracket from the instrument panel carrier.
8. Remove the column from the vehicle.

1. Install the column to the vehicle.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.




2. Install the column bracket to the instrument panel carrier.

Tighten
Tighten the support bolts and the nut to 25 N·m (18 lb ft).

3. Install the electrical connectors.



4. Install the steering column to the intermediate shaft. Refer to Intermediate Steering Shaft Replacement .
5. Remove the J-42640 anti-rotation pin from the lower steering column shroud access hole.
6. Install the shift cable to the steering column.
7. Install the left knee bolster. Refer to Driver Knee Bolster Replacement in Instrument Panel Gauges and Console.
8. Enable the SIR system. Refer to Enabling the SIR System in SIR.