For 1990-2009 cars only
Assembly Procedure
- Align the block tooth on the steering shaft assembly (1) to the 12 o'clock position.
- Install the wave washer (1) onto the steering shaft assembly.
- Align the inflatable restraint steering wheel module coil assembly (4) with the horn tower on the turn signal cancel cam assembly (1).
- If installing the existing inflatable restraint steering wheel module coil assembly it must be centered first. Refer to Inflatable Restraint Coil Centering - Off Vehicle .
- Slide the new inflatable restraint steering wheel module coil assembly (4) onto the steering shaft assembly (2).
- Firmly seat the new retaining ring (3) into the groove on the steering shaft assembly (2).
- Remove the centering tab from the new inflatable restraint steering wheel module coil assembly (4).
- Discard the centering tab.
- Attach new wire harness straps (2) to the wire harness assembly (1) and the steering column.
- Install the upper and lower shrouds. Refer to Trim Covers, Shift Lever Seal - Assemble - Off Vehicle .
Important: The new inflatable restraint steering wheel module coil assembly is pre-centered. Do not remove the centering tab from the new inflatable restraint steering wheel module coil assembly until the installation is complete.
