Was the Wiper/Washer System Check performed?

--

Go to Step 2

Go to Wiper/Washer System Check

1. Disconnect the windshield wiper/washer switch connector C200.
2. Place the windshield wiper switch in the LO position.
3. Connect a J 39200 between cavity E5 for CKT 96 (GRY) and cavity E4 for CKT 93 (YEL) at the windshield wiper/washer switch.

Is the resistance near or equal to the specified value?

680 ohms

Go to Step 3

Go to Step 5

With J 39200 still connected, move the windshield wiper/washer switch through the delay range to the maximum delay position while observing the meter.

Do the readings increase in steps to the approximate value?

430 k ohms

Go to Step 4

Go to Step 5

1. Repair the open in CKT 96 (BRN) or CKT 143 (YEL) between the wiper/washer switch connector and the windshield wiper motor module.
2. If the wires are OK, replace the windshield wiper motor module.

Is the repair complete?

--

Go to Wiper/Washer System Check

--

Replace the windshield wiper/washer switch.

Is the repair complete?

--

Go to Wiper/Washer System Check

--