Tools Required

J 39232 Wiper Transmission Separator

1. Remove the wiper arms. Refer to Windshield Wiper Arm Replacement .
2. Remove the air inlet grille panel. Refer to Air Inlet Grille Panel Replacement .
3. Disconnect the electrical connector from the wiper motor.



4. Remove the four bolts retaining the wiper system drive module.



5. Remove the wiper system drive module from the vehicle.



6. Remove the drive link from the wiper motor crank arm with the J 39232 .



7. Remove the four bolts retaining the wiper transmission.
8. Remove the wiper transmission from the wiper drive system module.

Tools Required

J 39529 Wiper Transmission Installer

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

1. Install the wiper transmission onto the wiper drive system module with the four bolts.

Tighten
Tighten the two bolts to 7 N·m (62 lb in).




2. Install the drive link onto the wiper motor crank arm with the J 39529 .



3. Install the wiper drive system module on the vehicle.



4. Install the four bolts.

Tighten
Tighten the four bolts to 8 N·m (71 lb in).




5. Connect the electrical connector to the wiper motor.
6. Install the air inlet grille panel. Refer to Air Inlet Grille Panel Replacement .
7. Install the wiper arms. Refer to Windshield Wiper Arm Replacement .
8. Operate the wipers and check for proper operation.