Tools Required

1. Remove the drive belt . Refer to Drive Belt Replacement .
2. Remove the fan clutch. Refer to Fan Clutch Replacement in Engine Cooling.
3. Remove the fan shroud (lower). Refer to Fan Shroud Replacement in Engine Cooling.
4. Remove the starter motor. Refer to Starter Motor Replacement in Engine Electrical.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

Important: Make sure the teeth of the flywheel holding tool engage the engine flywheel teeth.

5. Install the J 42847 to the starter bolt holes.

Tighten
Tighten the J 42847 bolts to 50 N·m (37 lb ft).




6. Install the J 42846 onto the end of the crankshaft.



7. Install the J 38416-B (2) onto the J 42846 (1) in order to remove the crankshaft balancer. Place the legs of the J 38416-B into the recesses cast into the backside of the balancer inner hub.
8. Tighten the center screw of the J 38416-B until the crankshaft balancer is clear of the crankshaft nose.



9. Remove the J 42846 .
10. Remove the crankshaft balancer.
11. Remove the J 42846 from the end of the crankshaft.

Important: 

1. Install the crankshaft balancer onto the end of the crankshaft.
2. Install J 42845 to the crankshaft balancer.

Important: Apply the lubricant that comes with J 42845 each time the tool is used. Failure to lubricate the J 42845 may prevent the balancer from installing completely.

3. Using J 42845 install the balancer.
4. Tighten the J 42845 until the crankshaft balancer is completely seated against the crankshaft sprocket.



5. Remove the J 42845 from the crankshaft.




Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

6. Install the crankshaft balancer washer and bolt.

Tighten
Tighten the crankshaft balancer bolt to 255 N·m (189 lb ft).

7. Remove J 42847 .
8. Install the starter motor. Refer to Starter Motor Replacement in Engine Electrical.
9. Install the fan shroud (lower). Refer to Fan Shroud Replacement in Engine Cooling.
10. Install the fan clutch. Refer to Fan Clutch Replacement in Engine Cooling.
11. Install the drive belt. Refer to Drive Belt Replacement .