Caution: Batteries produce explosive gases, contain corrosive acid, and supply levels
of electrical current high enough to cause burns. Therefore, to reduce the risk of
personal injury when working near a battery:
• | Always shield your eyes and avoid leaning over the battery whenever possible. |
• | Do not expose the battery to open flames or sparks. |
• | Do not allow the battery electrolyte to contact the eyes or the skin.
Flush immediately and thoroughly any contacted areas with water and get medical help. |
• | Follow each step of the jump starting procedure in order. |
• | Treat both the booster and the discharged batteries carefully when using
the jumper cables. |
Important: Because of the materials used in the manufacture
of automotive lead-acid batteries, dealers and service shops that handle them are
subject to various regulations issued by OSHA, EPA, DOT, and various state or local
agencies. Other regulations may also apply in other locations. Always know and follow
these regulations when handling batteries.
Batteries that are no longer wanted must be disposed of by an approved battery
recycler and must never be thrown in the trash or sent to a landfill.
Batteries that are not part of the vehicle itself, not the battery under the
hood, must only be transported on public streets for business purposes via approved
hazardous material transportation procedures.
Battery storage, charging, and testing facilities in repair shops must meet
various requirements for ventilation, safety equipment, material segregation, etc.
The maintenance-free battery is standard. There are no vent plugs in the cover.
The battery is completely sealed except for 2 small vent holes in the side. These
vent holes allow the small amount of gas that is produced in the battery to escape.
The battery has 3 functions as a major source of energy:
• | Alternate source of energy with generator overload |
The battery specification label, example below, contains information about the
following:
• | The original equipment catalog number |
• | The recommended replacement model number |
Battery Ratings
A battery may have 3 ratings:
• | Cold cranking amperage |
When a battery is replaced, use a battery with similar ratings. Refer to the
battery specification label on the original battery or refer to
Battery Usage
.
Amp Hour
The amp hour rating of a battery is the amount of time it takes a fully charged
battery, being discharged at a constant rate of 1 amperes and a constant temperature
of 27°C (80°F), to reach a terminal voltage of 10.5 volts. Refer to
Battery Usage
for the amp hour rating of
the original equipment battery.
Reserve Capacity
Reserve capacity is the amount of time in minutes it takes a fully charged battery,
being discharged at a constant rate of 25 amperes and a constant temperature
of 27°C (80°F), to reach a terminal voltage of 10.5 volts. Refer to
Battery Usage
for the reserve capacity rating of the
original equipment battery.
Cold Cranking Amperage
The cold cranking amperage is an indication of the ability of the battery to
crank the engine at cold temperatures. The cold cranking amperage rating is the minimum
amperage the battery must maintain for 30 seconds at -18°C (0°F)
while maintaining at least 7.2 volts. Refer to
Battery Usage
for the cold cranking amperage rating for this vehicle.