GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2009 🢒 Express 🢒 Engine 🢒 Engine Mechanical - 4.8L, 5.3L, 6.0L, 6.2L, or 7.0L 🢒 Engine Mount Bracket Replacement - Left Side

Removal Procedure

    Caution: Refer to Engine Mounting Caution in the Preface section.


    Object Number: 829685 Size: SH
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
  2. Remove the engine mount to engine mount bracket bolts.

    3. Object Number: 374320 Size: SH

    Caution: When raising or supporting the engine for any reason, do not use a jack under the oil pan, any sheet metal, or crankshaft balancer. Jacking against the oil pan may cause it to crack or break.

    Note: Raise the engine only enough to permit removal of the engine mount bracket.

  3. Using a jack on the square tab at the rear of the engine block and raise the engine, left side shown.

    4. Object Number: 829676 Size: SH
  4. Remove the engine mount bracket mounting nuts
  5. Remove the engine mount bracket from the vehicle.

Installation Procedure

    Object Number: 829676 Size: SH
  1. Install the engine mount bracket to the vehicle.

    2. Caution: Refer to Fastener Caution in the Preface section.

  2. Install the engine mount bracket retaining nuts and tighten to 45 N·m (33 lb ft).
  3. Lower the engine.

    4. Object Number: 829685 Size: SH
  4. Install the engine mount to engine mount bracket bolts and tighten to 60 N·m (44 lb ft).
  5. Lower the vehicle.