GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2009 🢒 Express 🢒 Diagnostic Navigation 🢒 Vehicle Diagnostic Information 🢒 Washer Pump Replacement

Removal Procedure

    Object Number: 497983 Size: SH
  1. Open and support the hood.
  2. Remove the upper fender support.
  3. Remove the bolt from the washer solvent container.

    4. Object Number: 497985 Size: SH
  4. Lift the washer solvent container up enough past the horns in order to access the washer hose and the electrical connector.
  5. Disconnect the electrical connector from the washer pump.
  6. Disconnect the washer hose from the washer pump.
  7. Place a cap on the washer pump to prevent any washer solvent loss.
  8. Remove the washer solvent container from the vehicle.
  9. Drain the washer solvent into a suitable container.

    10. Object Number: 497987 Size: SH
  10. Remove the washer pump from the washer solvent container.
  11. Remove the washer solvent container cap.

Installation Procedure

    Object Number: 497987 Size: SH
  1. Install the new washer pump into the washer solvent container.
  2. Install the washer solvent container cap.

    3. Object Number: 497985 Size: SH
  3. Connect the electrical connector to the new washer pump.
  4. Connect the washer hose to the new washer pump.
  5. Position the washer solvent container into the locating holes in the chassis.

    6. Caution: Refer to Fastener Caution in the Preface section.


    Object Number: 497983 Size: SH
  6. Install the washer solvent container with the bolt and tighten to 10 N·m (89 lb in).
  7. Install the upper fender support.
  8. Fill the washer solvent container.
  9. Close the hood.