GM Service Manual Online
For 1990-2009 cars only

Removal Procedure

  1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle.
  2. Remove the electrical connector from the speed sensor.

  3. Object Number: 97102  Size: SH
  4. Remove the bolt.
  5. Remove the speed sensor and the O-ring seal.
  6. Inspect the seal and the transmission case. Replace the seal, if necessary.

Installation Procedure


    Object Number: 97102  Size: SH
  1. Install the speed sensor and the O-ring seal into the transmission.
  2. Caution: Refer to Fastener Caution in the Preface section.

  3. Install the bolt and tighten to 11 N·m (97 lb in).
  4. Install the electrical connector to the speed sensor.
  5. Lower the vehicle.