Removal Procedure
- Open cover and remove screw, if equipped with roof rail inflatable restraints.
- Pull out on the center pillar garnish (1 ,2) molding to disengage the clips.
- Remove the center pillar garnish molding.
Installation Procedure
- Align the body side upper (1 ,2) garnish molding clips to the holes in the body.
- Push in on the body side upper (1 ,2) garnish molding to engage the clips.
Caution: Refer to Fastener Caution in the Preface section.
- Install screw and close cover, if equipped with roof rail inflatable restraints and tighten to
2 N·m(18 lb in).