Tools Required

J 41416 Ultrasonic Leak Detector

Caution: Natural gas is highly flammable. In order to reduce the risk of fire and personal injury, keep sparks, flames, and smoking materials away from the vehicle while you perform the Compressed Natural Gas (CNG) fuel system service.

Caution: The Compressed Natural Gas (CNG) system operates at pressures up to 24820 kpa (3600 psi). Relieve the CNG fuel system pressure before servicing CNG fuel system components in order to reduce the risk of fire and personal injury.

1. Relieve the CNG fuel system pressure. Refer to the Fuel Pressure Relief .

Relieve the CNG fuel system pressure. Refer to the Fuel Pressure Relief .

Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.

2. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection in Engine Electrical in the G Van Service Manual.
3. Remove the engine cover. Refer to Engine Cover Replacement in Interior Trim in the G Van Service Manual.



4. Remove the fuel line (6) at the low pressure lock-off solenoid fitting (5).



5. Remove the fuel line (1) from the high pressure regulator (2).



6. Remove the fuel line retainer (2) located along the transmission bellhousing (4) from the CNG fuel line (3) and the gasoline fuel line (1).
7. Remove the fuel line assembly from the vehicle.

1. Route the fuel line between the low pressure lock-off solenoid and the high pressure regulator.




Caution: Natural gas is stored under high pressure. If a leak occurs, the high pressure could cause a personal injury. In order to prevent Compressed Natural Gas (CNG) fuel leaks, always replace the CNG fuel system O-rings during service.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Connect the fuel line (6) at the low pressure lock-off solenoid fitting (5) using new O-rings . Lubricate the O-rings with petroleum jelly or equivalent before installation.

Tighten
Tighten the fuel line to 37 N·m (27 lb ft).




3. Connect the fuel line (1) at the high pressure regulator (2) fitting using new O-rings . Lubricate the O-rings with petroleum jelly or equivalent prior to installation.

Tighten
Tighten the fuel line to 37 N·m (27 lb ft).




4. Install the fuel line retainer (2) between the CNG fuel line (3) and the lower gasoline fuel line (1).
5. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection in Engine Electrical in the G Van Service Manual.
6. Prime the CNG fuel system by cycling the ignition ON and OFF several times.
7. Start the engine and use the J 41416 in order to inspect for CNG fuel system leaks at each serviced fitting.
8. Install the engine cover. Refer to Engine Cover Replacement in Interior Trim in the G Van Service Manual.