Tools Required
| • | Inside Mirror Adhesive Kit GM P/N 1052369 (Canadian P/N 993362)
or equivalent |
| • | Safety Razor or Utility Knife |
- Determine the location of the mirror mounting base by marking the outside
of the windshield with a marking pencil where the base was previously located. If
it is not clear where the base was mounted, use the following steps to determine where
the base should be installed:
| 1.1. | Using a measuring tape, measure the distance
between the windshield pillars at the windshield blackout line. |
| 1.2. | Using a marking pencil, halfway between the windshield pillars, draw a
centerline (1) on the windshield from the roof panel to the windshield base. |
| 1.3. | Draw a perpendicular line intersecting the centerline (2) at that
location. |
The bottom center of the mirror mounting base will be at the intersection of
these lines.
- Scrape the inside windshield glass thoroughly with a safety razor or utility
knife in order to remove all old adhesive.
- If reinstalling the original mounting base, place the mirror mounting
base in a suitable holding device, such as a vice.
- Scrape the mirror mounting base thoroughly with a safety razor or utility
knife in order to remove all old adhesive.
- Clean the inside windshield glass and the mounting surface of the mirror
mounting base thoroughly with a clean cloth saturated with naphtha or a 50/50 mixture,
by volume, of clean water and isopropyl alcohol.
- Apply a small amount of activator to the
mounting surface of the mirror mounting base.
- Apply a small amount of activator to the windshield where the mounting
base is to be installed.
- Allow the activator to dry 5 minutes.
Important: Do not touch the mounting surface of the mirror mounting base or the glass.
- Apply 1 drop of adhesive to the center of the mirror mounting base.
- Immediately apply the mounting base to
the windshield, ensuring that the mounting base aligns correctly to the marks made
on the outside of the windshield.
- Hold the mounting base firmly in place for 1 minute.
- Allow the adhesive to set for 15 minutes.
- Install the mirror to the mirror mounting base and fasten, if necessary.
- Connect the electrical connector and install the wire cover, if equipped.
