Fuel Hose/Pipes Assembly Replacement Passenger/Cargo Van Fuel Tank Pipes

Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.

1. Disconnect the negative battery cable.
2. Relieve the fuel system pressure. Refer to Fuel Pressure Relief .
3. Drain the fuel tank. Refer to Fuel Tank Draining .
4. Remove the fuel tank. Refer to Fuel Tank Replacement .
5. Remove the fuel feed and return pipes (6) from the fuel sender (1), the fuel filter, and the retaining clips.

1. Install the fuel feed and return pipes (6) to the fuel sender (1), the fuel filter, and the retaining clips.
2. Install the fuel tank. Refer to Fuel Tank Replacement .
3. Lower the vehicle.
4. Refill the fuel tank.
5. Tighten the fuel filler cap.
6. Connect the negative battery cable.
7. Inspect for leaks:

7.1.	Turn ON the ignition for 2 seconds.

7.2.	Turn OFF the ignition for 10 seconds.

7.3.	Turn ON the ignition .

7.4.	Inspect for fuel leaks.

Fuel Hose/Pipes Assembly Replacement Cutaway Van Rear Tank Fuel Tank Pipe

Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.

1. Disconnect the negative battery cable.
2. Relieve the fuel system pressure. Refer to Fuel Pressure Relief .
3. Drain the fuel tank. Refer to Fuel Tank Draining .
4. Remove the fuel tank. Refer to Fuel Tank Replacement .
5. Remove the fuel feed and return pipes (4) from the fuel sender (2).

1. Install the fuel feed and return pipes (4) to the fuel sender (2).
2. Install the fuel tank. Refer to Fuel Tank Replacement .
3. Lower the vehicle.
4. Refill the fuel tank.
5. Tighten the fuel filler cap.
6. Connect the negative battery cable.
7. Inspect for leaks:

7.1.	Turn ON the ignition for 2 seconds.

7.2.	Turn OFF the ignition for 10 seconds.

7.3.	Turn ON the ignition.

7.4.	Inspect for fuel leaks.