Schematic Reference: Horn Schematics

Connector End View Reference: Horn Connector End Views

Did you perform the Diagnostic System Check - Vehicle?

Go to Step 2

Go to Diagnostic System Check - Vehicle

Depress the horn switch.

Do the horns have a harsh tone or buzzing?

Go to Step 3

Go to Testing for Intermittent Conditions and Poor Connections

1. Test the horn mounting hardware for adequate torque. The hardware should be tightened to 10 N·m (7 lb ft).
2. Inspect the horns for debris in the joint where the horns attach to the vehicle.

Did you find and correct the condition?

Go to Step 7

Go to Step 4

1. Disconnect the horn connector.
2. Connect a 15 amp fuse jumper wire between the positive battery terminal and the control terminal of the horn.
3. Connect another jumper wire between the negative battery terminal and the ground terminal of the horn.

Do the horns have a harsh tone or buzzing?

Go to Step 6

Go to Step 5

Repair the high resistance in the horn control circuit or the horn ground circuit. Refer to Circuit Testing and Wiring Repairs .

Did you complete the repair?

Go to Step 7

--

Replace the horns. Refer to Horn Replacement .

Did you complete the replacement?

Go to Step 7

--

Operate the horns.

Do the horns operate properly?

System OK

Go to Step 1