GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2007 🢒 Express - AWD 🢒 Diagnostic Navigation 🢒 Vehicle Diagnostic Information 🢒 Camshaft Position Sensor Exciter Ring Replacement

Removal Procedure

    Object Number: 738905 Size: SH
  1. Remove the engine front cover. Refer to Engine Front Cover Replacement .

    2. Notice: Do not use an impact driver to remove or install the oil pump driven gear nut. Use of an impact driver may shear the oil pump drive gear pin in the crankshaft.

  2. While holding the secondary oil pump shaft with a hex driver, remove the oil pump driven gear nut.
  3. Remove the oil pump driven gear.

    4. Object Number: 738904 Size: SH

    Important: DO NOT remove the reluctor from the oil pump drive gear. The reluctor is timed to the gear and once removed the correct timing will be lost.

  4. Remove the oil pump drive gear and crankshaft sensor reluctor.

    5. Object Number: 739316 Size: SH
  5. Remove the camshaft reluctor screws.
  6. Remove the camshaft reluctor.

Installation Procedure

    Object Number: 739316 Size: SH
  1. Position the camshaft reluctor to the camshaft gear.

    2. Notice: Refer to Fastener Notice in the Preface section.

  2. Install the camshaft reluctor bolts.

    3. Tighten
    Tighten the bolts to 9 N·m (80 lb in).


    Object Number: 738904 Size: SH

    Important: Do not damage the teeth on the reluctor.

  3. Install the oil pump drive gear and reluctor to the crankshaft.

    4. Object Number: 738905 Size: SH
  4. Install the oil pump driven gear.

    5. Notice: Do not use an impact driver to remove or install the oil pump driven gear nut. Use of an impact driver may shear the oil pump drive gear pin in the crankshaft.

  5. While holding the secondary oil pump shaft with a hex driver, install the oil pump driven gear nut.

    6. Tighten
    Tighten the nut to 100 N·m (74 lb ft).

  6. Install the engine front cover. Refer to Engine Front Cover Replacement .