GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2007 🢒 Express - AWD 🢒 Diagnostic Navigation 🢒 Vehicle Diagnostic Information 🢒 Exhaust Particulate Filter Replacement

Exhaust Particulate Filter Replacement 6.6L - (LMM)

Removal Procedure

    Object Number: 1863118 Size: SH
  1. Remove the tail pipe. Refer to Tail Pipe Replacement .
  2. Remove the exhaust temperature sensors. Refer to Exhaust Temperature Sensor Replacement - Position 1 and Exhaust Temperature Sensor Replacement - Position 2 .
  3. Remove the exhaust pressure differential sensor pipe. Refer to Exhaust Pressure Differential Sensor Pipe Replacement .
  4. Remove the catalytic converter to particulate filter nuts.
  5. Remove the exhaust particulate filter.
  6. Remove and discard the exhaust particulate filter gasket.

Installation Procedure

    Object Number: 1863118 Size: SH
  1. Install a NEW gasket onto the catalytic converter studs.
  2. Install the exhaust particulate filter.

    3. Notice: Refer to Fastener Notice in the Preface section.

  3. Install the catalytic converter to particulate filter nuts.

    4. Tighten
    Tighten the nuts to 40 N·m (30 lb ft).

  4. Install the exhaust pressure differential sensor pipe. Refer to Exhaust Pressure Differential Sensor Pipe Replacement .
  5. Install the exhaust temperature sensors. Refer to Exhaust Temperature Sensor Replacement - Position 1 and Exhaust Temperature Sensor Replacement - Position 2 .
  6. Install the tail pipe. Refer to Tail Pipe Replacement .
  7. Using a scan tool, perform the DPF Reset For Replace DPF.