Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
Schematic Reference: Audible Warnings Schematics Connector End View Reference: Data Communication Connector End Views DEFINITION: The chime sounds with the driver's door open. | ||||
1 | Did you perform the Diagnostic System Check - Vehicle? | -- | Go to Step 2 | |
2 | Do any indicators illuminate when the chime sounds? | -- | Go to Step 3 | |
3 |
Does the chime sound? | -- | Go to Step 4 | Go to Testing for Intermittent Conditions and Poor Connections |
4 | Disconnect the body control module (BCM). Does the chime sound? | -- | Go to Step 5 | Go to Step 6 |
5 | Is the vehicle equipped with a chime module (UL5)? | -- | Go to Step 10 | Go to Step 11 |
6 |
Does the Parklamp Switch parameter display Inactive? | -- | Go to Step 7 | |
7 |
Does the Driver Door Ajar parameter display Inactive? | -- | Go to Step 8 | Go to Courtesy Lamps Always On |
8 |
Does the test lamp illuminate? | -- | Go to Step 9 | Go to Step 12 |
9 | Test the key in ignition switch signal circuit for a short to ground. Refer to Circuit Testing and Wiring Repairs . Did you find and correct the condition? | -- | Go to Step 18 | Go to Step 13 |
10 | Inspect for poor connections at the harness connector of the chime module. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs . Did you find and correct the condition? | -- | Go to Step 18 | Go to Step 14 |
11 | Inspect for poor connections at the harness connector of the radio. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs . Did you find and correct the condition? | -- | Go to Step 18 | Go to Step 15 |
12 | Inspect for poor connections at the harness connector of the BCM. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs . Did you find and correct the condition? | -- | Go to Step 18 | Go to Step 16 |
13 | Inspect for poor connections at the harness connector of the ignition key alarm switch. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs . Did you find and correct the condition? | -- | Go to Step 18 | Go to Step 17 |
14 | Replace the chime module. Refer to Control Module References for replacement, setup, and programming. Did you complete the replacement? | -- | Go to Step 18 | -- |
15 | Replace the radio. Refer to Radio Replacement . Did you complete the replacement? | -- | Go to Step 18 | -- |
16 | Replace the BCM. Refer to Control Module References for replacement, setup, and programming. Did you complete the replacement? | -- | Go to Step 18 | -- |
17 | Replace the ignition key alarm switch. Refer to Ignition and Start Switch Replacement . Did you find and correct the condition? | -- | Go to Step 18 | -- |
18 | Operate the system in order to verify the repair. Did you correct the condition? | -- | System OK | Go to Step 2 |
