Schematic Reference: Instrument Cluster Schematics

Connector End View References: Master Electrical Component List

1

Did you perform the Diagnostic System Check - Vehicle?

Go to Step 2

Go to Diagnostic System Check - Vehicle

1. Install a scan tool.
2. Turn ON the ignition, with the engine OFF.
3. With the scan tool, perform the Displays Test.

Does the engine oil pressure gage move from 0 to its maximum value and back to 0 when you perform the Displays Test?

Go to Testing for Intermittent Conditions and Poor Connections

Go to Step 3

Replace the instrument panel cluster (IPC). Refer to Control Module References for replacement, setup, and programming.

Did you complete the replacement?

Go to Step 4

--

Operate the system in order to verify the repair.

Did you correct the condition?

System OK

Go to Step 2