Schematic Reference: Instrument Cluster Schematics

Connector End View References: Displays and Gages Connector End Views

Did you perform the Diagnostic System Check - Vehicle?

Go to Step 2

Go to Diagnostic System Check - Vehicle

1. Turn ON the ignition, with the engine OFF.
2. Observe the instrument panel cluster (IPC).

Does the IPC perform the displays test?

Go to Testing for Intermittent Conditions and Poor Connections

Go to Step 3

1. Turn OFF the ignition.
2. Disconnect the IPC.
3. Turn ON the ignition, with the engine OFF.
4. Connect a test lamp between the ignition 1 voltage circuit of the IPC and a good ground.

Does the test lamp illuminate?

Go to Step 4

Go to Step 7

Connect a test lamp between the ignition 1 voltage circuit of the IPC and the ground circuit of the IPC.

Does the test lamp illuminate?

Go to Step 5

Go to Step 6

Inspect for poor connections at the harness connector of the IPC. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs .

Did you find and correct the condition?

Go to Step 9

Go to Step 8

Repair the open or the high resistance in the IPC ground circuit. Refer to Circuit Testing and Wiring Repairs .

Did you complete the repair?

Go to Step 9

--

Repair the open, the short to ground or the high resistance in the ignition 1 voltage circuit. Refer to Circuit Testing and Wiring Repairs .

Did you complete the repair?

Go to Step 9

--

Replace the IPC. Refer to Control Module References for replacement, setup, and programming.

Did you complete the replacement?

Go to Step 9

--

Operate the system in order to verify the repair.

Did you find and correct the condition?

System OK

Go to Step 3