Removal Procedure
- Release the park brake.
- Disable the park brake cable automatic adjuster. Refer to
Parking Brake Cable Adjuster Disabling
.
- Raise and support the vehicle. Refer to
Lifting and Jacking the Vehicle
.
- Disconnect the cable at the equalizer.
- For cutaway vehicles only, remove the cable from the mounting bracket by depressing
the locking tabs.
- Pass the cable through the cable guides on the frame.
- Perform the following procedure to remove the cable (2) from the backing plate (4).
| 7.1. | Compress the spring (3) by pushing towards the lever (1). |
| 7.2. | Depress the locking tabs. |
| 7.3. | Pull the cable housing out of the backing plate (4). |
| 7.4. | Remove the cable (2) through the slot in the backing plate. |
- Remove the park brake cable (2) from the lever (1).
- Remove the cable from the vehicle.
Installation Procedure
- Install the cable to the vehicle.
- Install the park brake cable (2) to the lever (1).
- Perform the following procedure to install the cable (2) to the backing plate (4).
| 3.1. | Compress the spring (3) by pushing toward the lever (1). |
| 3.2. | Route the cable (2) through the slot in the backing plate. |
| 3.3. | Push the cable housing into the backing plate (4) until the locking tabs snap into place. |
- Pass the cable through the cable guides on the frame.
- For cutaway vehicles only, install the cable to the mounting bracket until the
locking tabs snap into place.
- Connect cable at the equalizer.
- Remove the safety stands.
- Lower the vehicle.
- Enable the park brake cable automatic adjuster. Refer to
Parking Brake Cable Adjuster Enabling
.
- Adjust the park brake cable. Refer to
Park Brake Adjustment
.
